In the early years of production manufacture was shared between two factories. While mechanically the same, the Austin Seven and Morris Mini used their own trim designs and these designs varied throughout these years until trim became more standardised after 1962. This design was used exclusively in early Austin production, and fits seats with the curved tubular rear legs and flat front legs as pictured below. As with all early Mini items there was a lot of changes in the these early production years so if you are unsure we would recommend contacting our sales team for further details.
Please note that originally seats of this design would have had the matching piping colour, the seats pictured were a special order with a contrasting light grey piping typically used on earlier Austin Minis - if you would like to have with grey piping please contact our sales team
These covers feature 11 welded flute lines on the face, made in our Fleck material which we have had painstakingly remanufactured to get as close to the original material as possible. These welded seat covers were normally fitted to earlier vehicles without the wire squab frame assembly for the rear seats - this can help determine which seat covers are more period for your Mini. The back of the seat is made in the contrasting vinyl colour, on Morris produced cars the rear of the seat was produced in the Fleck material. This kit is for both front seat covers.
Please note that colours listed are those that were used in the original manufacture of the vehicle. We do, however, have a number of other colours which are available to order – please check out our colour swatches section at the bottom of the page to see the wide range of other colours available or get in touch with our sales team who will be happy to send samples. If you would like to order a colour that is not listed please contact our sales team who can advise the best way to proceed
Newton Commercial Part No - SC3106