In the early years of production manufacture was shared between two factories. While mechanically the same, the Austin Seven and Morris Mini used their own trim designs and these designs varied throughout these years until trim became more standardised after 1962. This design was used exclusively in early Austin production, and fits the post leg front seat frames (as pictured below). As with all early Mini items there was a lot of changes in the these early production years so if you are unsure we would recommend contacting our sales team for further details.
These covers feature the narrow welded flute lines which run across each seat face, joined on the base to a rollover front pad. The seat faces are made in our Fleck material which we have had painstakingly remanufactured to get as close to the original material as possible. The front knee roll and the back of the seat are made in the contrasting vinyl colour, on Morris produced cars the rear of the seat was produced in the Fleck material. These seats were made with a light grey contrasting piping, however if you would prefer the matching piping colour please let us know at point of order.
Please note that colours listed are those that were used in the original manufacture of the vehicle. We do, however, have a number of other colours which are available to order – please check out our colour swatches section at the bottom of the page to see the wide range of other colours available or get in touch with our sales team who will be happy to send samples. If you would like to order a colour that is not listed please contact our sales team who can advise the best way to proceed
Newton Commercial Part No - SC3118
