VITESSE MK.2 FRONT SEAT KIT

The front seats on the Vitesse Mk.2 models look very similar to the Mk.1 seats as well as the Herald 13/60 range. There is a difference though. The Mk.2 seats had originally a sprung system on the squab area whereas previous seats had just rubber straps. The only way to tell from the outside of the seat is to measure the distance from the top of the face flutes, over the top of the seat to the stitch line on the rear of the cover. This measurement should be 345mm. On the MK.1 Vitesse seats this measurement is 295mm. You should also check the condition of the spring system on the squab area. If this is broken and not repairable, we have developed a new system to replace it. We have tried to remanufacture these springs, but the cost for small quantities made it too expensive. Please refer to part number SF4025 for our conversion kit. If your springs are in good order but the straps are worn please refer to part number ST907.

Please note that colours listed are those that were used in the original manufacture of the vehicle. We do, however, have a number of other colours which are available to order – please check out our colour swatches section at the bottom of the page to see the wide range of other colours available or get in touch with our sales team who will be happy to send samples. If you would like to order a colour that is not listed please contact our sales team who can advise the best way to proceed.

Newton Commercial Part No - SC4015

View fitting instructions